Oil Separator Cover & Piston Pin Cover Kit

オイルセパレータカバーキット

£119.95

In stock

Add to Wishlist
Add to Wishlist
SKU: FREN104 Category:

The Separator Cover.

The FUJI Racing oil separator plate is the perfect addition when rebuilding your EJ Series engine or when installing a new clutch and flywheel.

The oil separator plate is located on the rear of the engine block and can be seen when the gearbox / bell housing is removed.

Many Subaru EJ boxer engines were fitted with a plastic separator plate from factory (which over time tend to leak due to fatigue caused by age and heat cycles). Later on in the EJ’s history presumably Subaru realised the problem and switched to a thin pressed cover as a more reliable alternative.

The FUJI Racing oil separator plate is based on a very early design that Subaru initially produced which featured a far thicker wall of material, allowing a more uniformed pressure to be applied across the sealing face providing a leak free solution for years to come.

Additional information

Weight 0.47 kg
Dimensions 26 × 13 × 8 cm
Models

Forester SF 96-02, Forester SG 02-08, Forester SH 08-12, Impreza GC/GF/GM 92-00, Impreza GD/GG 00-07, Impreza GR/GV/GH 07-14, Legacy BC/BF/BJ 90-94, Legacy BD/BG 94-98, Legacy BE/BH 98-03, Legacy BL/BP 03-09, WRX STi VAB/VAF 14-21

The Pin Cover.

A simple but beautifully made product, our piston pin cover plate is a direct replacement for the factory part and can be found located at the rear of the engine block (opposite to where the gearbox bell housing locates).

It’s function is to allow access to the inside of the engine to remove the piston gudgeon pins and when not needed is permanently sealed.

As EJ engines age both the piston pin cover plate and the oil separator plate (also located in a similar area) can start to weep oil and in some cases leak considerably.

Our replacement pin cover plate is supplied with new counter sunk screws and a replacement o-ring seal to provide the perfect seal for many more years to come.

Model Application:

Suitable for the following models:

  • All EJ Engines

If you are unsure of fitment or application then please contact us with your vehicles chassis number.

What's in the kit:

  • 1 x T6061 Billet oil separator cover
  • 6 x Counter sunk separator cover bolts
  • 1 x T6061 Billet Piston pin cover
  • 2 x Counter sunk piston pin cover bolts
  • 1 x Piston pin cover viton o-ring seal

NOTE: We recommend using thread lock on the end of each bolt to provide a secure seal.